[Source] OpenGL version of extrusions (Xj3D) status

[Don Brutzman]

cc: list

On 8/26/2012 12:49 AM, Norbraten, Terry (CIV) wrote:
> Interesting, just found this statement from here: http://www.xj3d.org/status.html
> 
> Extrusion
>     OpenGL version does not handle end caps correctly, nor creaseAngle.

interesting.  based on trouble shooting so far, i think it doesn't handle
- end cap scaling nor
- orientations array, in certain cases.

i've narrowed down the error-producing cases but have not fully isolated
the problem causes in the parameter settings.

all the best, Don
-- 
Don Brutzman  Naval Postgraduate School, Code USW/Br       brutzman at nps.edu
Watkins 270,  MOVES Institute, Monterey CA 93943-5000 USA   +1.831.656.2149
X3D graphics, virtual worlds, navy robotics http://faculty.nps.edu/brutzman